help • 12 Devices • DECT telephones • Commissioning the DCF DECT system • Activating DECT system
12.3.1.5 Activating DECT system
To activate the new DECT system and put all assigned DECT end devices into operation, you must configure a base station.
* 
You only need to configure the base station that you want to use as the master. The other base stations assigned to the DECT system are automatically recognized.
 
* 
A factory reset must be carried out on the base station that you want to configure as the master, see 12.3.3 Performing a factory reset.
 
* 
The master base station is assigned the AirSync role.
Therefore, place the base station centrally and within range of all other base stations in the DECT system.
 
Requirements:
*All DECT base stations are connected to your LAN and switched on. The master base station has firmware 11.4.4 or higher with a factory reset, see 12.3.1.1 Prepare hardware.
*DECT system objects (including base stations and handsets) have been created, see 12.3.1.2 Creating a DECT system
*Have the following data ready:
- MAC address of the base station,
- Activation key,
- Provisioning-URL.
You can find this data in Swyx Control Center at Devices | DECT | DECT Base Stations | Edit DECT Base Station (). You have to activate the checkbox Show configuration info check box.
Click to copy the corresponding data to the clipboard.
* 
To open the administration web interface within the local network, you can also use the following line in the browser instead of the IP address of the base station: https://<Base station model>-<last three bytes of the MAC address>.

e.g. http://ipbs3-28-07-bb

The corresponding data can be found on the white label on the underside of the base station.
 
* 
If you cannot open the configuration wizard, carry out a factory reset, see 12.3.3 Performing a factory reset
 
To configure the master base station
1 Enter 'https://<IP address of the master base station>' in the address bar of your browser to open the administration web interface of the device.
*The login dialog appears.
2 Enter the default name "admin" and the default password "changeme".
3 Click on Login and subsequently auf OK.
*The Ascom configuration wizard appears.
4 Select as Setup Type the Device Management Server (DMS):
s
5 Click on Next.
6 Upload a TLS root certificate if necessary.
This step is only necessary if you have enabled TLS configuration via SCST, see https://help.enreach.com/cpe/14.00/Administration/Swyx/en-US/#context/help/SCST.
7 Enter under URL enter the provisioning URL.
8 Enter under Username enter the MAC address of the base station with ":" or without separator.
e.g. a1:c2:e3:f4:11:12
9 Enter the password under Password and Confirm Password enter the activation key.
10 Click on Next.
11 Check your details.
12 Click on Finish.
*The base station is restarted The LED on the base station first flashes red, then blue. At the end of successful activation (can take up to two minutes), the LED lights up blue continuously.
It can take up to five minutes for other base stations to be activated. The base stations operating in a subnet must configure them manually, see 12.3.1.6 Configure subnet base stations (optional).