12.2.1.10 Check commissioning
You can check whether the new DECT system and the assigned end devices have been activated. After successful commissioning, new data must appear in the lines of the corresponding DECT objects:
 
You may need to refresh the page in Swyx Control Center to see the changes.
 
1 Select Devices | DECT.
2 Select the Tab DECT systems.
*D800 or D600 appears in the line of the corresponding DECT system in the Type column.
3 Select the Tab DECT base stations.
*In the rows of the created base stations the correct values appear in the columns Device type and Firmware version.
*In the line of the master base station the column Master is marked with a check mark.
4 Select the Tab Assigned handsets.
*In the rows of the created handsets the correct values appear in the columns Terminal type and Firmware version.
*The DECT handsets are assigned to all desired users.
The DECT system is activated and connected to SwyxServer. Users can make calls with their DECT handsets.
 
Make sure that the new firmware is fully downloaded before using the handsets.
 
 
To download the new firmware, the DECT 600 handsets must be in charging stations.
 
 
Downloading the firmware on DECT handsets can take up to 30 minutes, depending on the model.
You can check the status of the firmware on the DECT 800 handset via the administration menu: (see To unlock the administration menu).
Menu | Calls | Admin Menu | Centr. Management
- No FDL (No firmware download) - No firmware is downloaded.
- NN% - Firmware is being downloaded, NN% of the operation is finished.
 
 
You can check the status of the distribution of the new firmware for DECT 600 handsets on the web interface of the master base station.
On DECT 600 handset you can only check the current firmware version under Settings | Status | SW version.
 
How to put a DECT 600 handset into operation
1 Switch on the handset and wait until the start screen appears.
2 Press the menu button on the handset.
3 Select Connection | Register in the menu.
4 Enter the 4-digit number:
0000
5 Press OK.
*The handset is registered to the base station.
For more information on configuring the handset, see