Open the necessary INI file for your application case. Swyx recommends a text editor, which supports automatic syntax highlighting.
How to configure the gateway:
1. Under "[SYSTEM Params]", enter your DNS and NTP server.
As a rule, further settings are not necessary.
2. In the section "[ProxyIp]", configure the IP address of your IpPbxServer. If you use a standby system, activate the further options and configure the IP address of your standby system.
3. The following paragraphs describe the physical connection of SwyxConnect 6000. Activate the options appropriate for your usage.
If you configure an external line under "[TrunkGroup]", replace "NUMBER" with your subscriber number, e.g. 1234, for +49 231 1234 000 999.
If you operate a device on a port, replace "NUMBER" with the extension of the relevant subscriber, e.g.100, for +49 231 1234 100.
Under "[TrunkGroupSettings]", activate the lines according to the ports to be used.
4. Under "[Account]", specify the login data of your SIP gateway trunks and devices according to your SwyxWare configuration.
5. Under "[PSTN Params]", configure the protocol properties of the connections to be used.
6. The section "[PstnPrefix]" determines the routing of SwyxConnect 6000. If you operate SwyxConnect 6000 with external lines only, just put an asterisk for each port used. If you also run devices, configure the extension to be routed on the corresponding trunk group.
| The routing starts as soon as a corresponding number is found in the table. Since the asterisk acts like a wildcard, this applies to every dialed number. This line should therefore always have the highest index in this table.
If you want to use the SAS function with SwyxConnect 6000, the routing should be configured in the corresponding section of the INI file. |
For the SAS configuration, you then execute the following steps:
7. In the section "[ProxyIP]", enter the IP address of SwyxConnect 6000.
8. Under "[TrunkGroupSettings]" activate the parameters according to the ports configured under point 3.
9. Under "[Account]" activate the parameters according to the number of user accounts configured under point 4.
10. In the following section, numbers are configured which need special handling when dialing with Overlap Dialing, such as emergency numbers, exchange number or extensions of devices connected directly to SwyxConnect 6000. Replace the relevant wildcards here in order to adapt SwyxConnect 6000 to your environment.
11. The section "[PstnPrefix]" describes, as in point 6, the routing of SwyxConnect 6000 in gateway and SAS mode. Configure here the Routing Records for your external lines and connected devices, both for all used proxy IP addresses and for the local host IP address for SwyxConnect 6000.
12. Under "[SIP Params]", activate all parameters and configure the IP address of SwyxConnect 6000 once again.
13. The parameters described in the following sections must only be activated and generally need no further change.
