help • App. N: Approvals, Codes, Data Sheets • ISDN Card SX2 QuadBRI
N.1 ISDN Card SX2 QuadBRI
The SX2 QuadBRI is an ISDN card with four S0 connections. It works with Cologne Chip HFC-4S and was developed especially for the use with SwyxWare. It is manufactured exclusively for Enreach.
* 
This document will use SX2 QuadBRI, if both type of boards are characterized (SX2 QuadBRI and SX2-express DualPRI). Differences, e.g. in the power configuration, are pointed out especially.
 
ISDN Interface
*4 x BRI interface
*Each line can be configured individually using a jumper field for the TE or NT mode. The BRI connector (adapter to use an internal S0) is not necessary for the SX2 QuadBRI
*Short circuit resistance is provided for the ISDN connection via a special fuse (non-blowing, auto-recovery)
*Line termination (100Ohm) is adjustable for each connection individually via a DIP switch.
*A maximum of 4 different cards (SX2 QuadBRI, SX2 SinglePRI and SX2 DualPRI) can be used in one computer. In doing so, a maximum of 76 B channels will be supported. Please note that the SX2 DualPRI is counted as two cards because it will appear as two network cards in the Windows device manager.
PCI Interface
*SX2 QuadBRI
PCI Interface for 3.3V and 5V PCI 2.2 slots. If necessary, 5V is reduced to 3.3V using a voltage regulator located on the card.
*SX2-express DualPRI
The board has a PCI express x1 Interface without any further configuration.
PCM Highway
*Tact synchronization between the different SX2 cards is possible. The cards are connected with a ribbon cable.
* 
A mixed usage of PCI and PCI-express board is not supported (incompatible plugs).
 
*2/4/8 Mbit/s data transfer rate
*Chipset: Cologne Chip HFC-4S Chip
*Exact 49,152 MHz quartz oscillator
*512x8bit serial EEPROM for programming the PCI configuration information
Chipset
*Cologne Chip HFC-4S Chip
*Exact 49,152 MHz quartz oscillator
*512 x 8 bit serial EEPROM for programming the PCI configuration information
General purpose I/O
*Four two-color LEDs (red/green) on the mounting bracket of the SX2 QuadBRI
*Three DIP switches that can be used for the identification of the card
*You will find more recent drivers for the SX2 QuadBRI in the download area of the homepage:
Conformity Declaration
The ISDN card family SX2 conforms to the hardware specifications of the ISDN standards (I.430, CTR3).
Dimensions of the SX2 QuadBRI
15.5 x 10.5 x 1.3 cm