N.3 ISDN Card SX2 SinglePRI
SX2 SinglePRI1 x PRI
2m interface (SX2 SinglePRI)
The line can be configured individually using a jumper field for the TE or NT mode.
Line termination (120Ohm or 75Ohm) is adjustable via a DIP switch.
A maximum of 4 different cards (SX2 QuadBRI, SX2 SinglePRIand SX2 DualPRI) can be used in one computer. In doing so, a maximum of 76 B channels will be supported. Please note that the SX2 DualPRI is counted as two cards because it will appear as two network cards in the Windows device manager.
PCI Interface
PCI Interface for 3.3V and 5V PCI 2.2 slots. If necessary, 5V is reduced to 3.3V using a voltage regulator located on the card.
PCM Highway
Tact synchronization between the different SX2 cards is possible. The cards are connected with a ribbon cable.
2/4/8 Mbit/s data transfer rate
Chipset: Cologne Chip HFC-E1 Chip
Exact 32,768 MHz quartz oscillator
512x8bit serial EEPROM for programming the PCI configuration information
General purpose I/O
Four LEDs (red/green) on the mounting bracket of the ISDN card
Four DIP switches that can be used for the identification of the card
You will find more recent drivers for the SX2 in the download area of the homepage: