help • 1 Operating an Enreach DECT 600 system with SwyxWare • Manual setup via the web interface of the base station • Settings at the webinterface • Alarm
1.7.3.6 Alarm
You can define what happens when a user presses the emergency button on their handset. In this way, another contact can be quickly notified in the event of an emergency.
* 
An emergency/ alarm is always handset specific. So if a user uses multiple devices, you may need to apply the settings to each handset.
 
For each user you can individually create an emergency contact and choose between different alarm profiles.
In order to use the alarm function, you must have defined these settings for the user (for each one individually). An alarm is then triggered when a user presses their emergency button on their handset for 3 seconds.
To configure alarm profiles
1 Select Alarm.
*The list of the seven alarm profiles appears.
Web interface Alarm DECT 600 L
2 You can edit the following entries:
Function
Description
Profile Alias
Set a name for the profile.
Alarm type
Activate this function to enable the profile. Only then can an alarm button be used for the function.
Alarm Signal
Select Call.
Stop Alarm from Handset
Select whether the person triggering an alarm can end it on their handset.
Trigger Delay
Leave the trigger time at 0 seconds so that an emergency can be delivered immediately.
Stop Pre-Alarm from Handset
Enable this function to allow the trigger of an alarm to withdraw it itself (false alarm) before it is sent.
Pre-Alarm Delay
Specify an interval in seconds during which an emergency call can be withdrawn from the person triggering it.
Howling
Howling is an advisory tone that is a loud confirmation that sounds when an alarm has been sent.
3 Click on Save.