help • 1 Operating an Enreach DECT 600 system with SwyxWare • Manual setup via the web interface of the base station • Settings at the webinterface • Multi Cell
1.7.3.7 Multi Cell
In the area Multi Cell Settings you can perform the multi cell configuration for setting specific base stations.
Multi Cell Status
Function
Description
System Information
Status of the multi cell system.
Last packet received from IP
IP address of the last synchronized base station or repeater + time of synchronization.
Settings for this base
Function
Description
Multi Cell system
To enable the multi cell mode of the Enreach DECT 600, this option must be enabled.
Multi Cell ID
Displays the ID unique to a particular multi-cell. The System chain ID is not editable.
Synchronization time (s)
The duration in seconds after which links of base stations are synchronized with each other.
Data Sync
The DECT base stations are synchronized with each other via the network. Two types of synchronization can be selected:
Multicast (recommended):
Simultaneous distribution of synchronization data to all connected base stations. This function must be supported by the network hardware (switches). If this is not the case select Peer-To-Peer.
Peer-To-Peer:
With Peer-To-Peer, each base station is given another base station as a synchronization target. All base stations in the system are synchronized in the process. Then enter the corresponding IP address manually at Primary Data Sync IP.