B.2.2 Signaling via the LED at the Top of SwyxIt! Handset P300
Handset is on hook and LED flashes red
You are receiving an incoming call. As soon as you answer it, the LED will light up green.
Handset is lifted and LED lights up
The line is active.
|
Situation
|
Press the following button:
|
Result
|
|---|---|---|
|
The handset is on the hook and the phone rings.
|
Speaker
|
"Handsfree” mode is activated. The LED on the “Speaker” button lights up. The device speaker and room microphone of the handsfree equipment assigned to this audio mode are used. Pressing the “Speaker” button again will end the call.
|
|
The handset is on the hook.
|
Speaker
|
The LED on the “Speaker” button lights up. You hear the idle tone through the device speaker. You are free to dial a number. The resulting call will take place in “Handsfree” mode.
|
|
The handset is off the hook and you are in the middle of a call.
|
Speaker
|
The device speaker on the SwyxIt! Handset P280 is activated. The LED on the “Speaker” button lights up. If you want to speak, you must continue to use the microphone in the handset. By Pressing the “Speaker” button again, the device speaker is deactivated and the LED turns off.
|
|
The handset is on the hook and you are in the middle of a call via a connected headset.
|
Speaker
|
The device speaker on the SwyxIt! Handset P280 is activated. The LED on the “Speaker” button lights up. The handset and headset speakers are used for voice output. If you want to speak, you must continue to use the microphone in the headset. Pressing the “Speaker” button again deactivates the handset speaker and the LED turns off.
|
|
The handset is on the hook and you are in the middle of a call in "Handsfree” mode.
|
Speaker
|
The LED on the “Speaker” button goes out and the call is terminated.
|
If the “Handsfree” audio mode has been deactivated within the settings, calls can only be made via the handset or a connected headset.