help • 1 Operating an Enreach DECT 600 system with SwyxWare • Manual setup via the web interface of the base station • Settings at the webinterface • Dual Cell
1.7.3.7 Dual Cell
In the area Dual Cell Settings you can configure the dual cell system.
Dual Cell Status
Function
Description
System Information
Status of the dual cell system.
Last packet received from IP
IP address of the last synchronized base station or repeater + time of synchronization.
Settings for this base
Function
Description
Dual Cell System
Check this option to enable the Dual Cell mode of the Enreach DECT 600 S.
Multi Cell ID
Displays the ID unique to a particular multi-cell. The System chain ID is not editable.
Data Sync
The DECT base stations are synchronized with each other via the network. Two types of synchronization can be selected:
Multicast (recommended):
Simultaneous distribution of synchronization data to all connected base stations. This function must be supported by the network hardware (switches). If this is not the case select Peer-To-Peer.
Peer-To-Peer:
With Peer-To-Peer, each base station is given another base station as a synchronization target. All base stations in the system are synchronized in the process. Then enter the corresponding IP address manually at Primary Data Sync IP.
Base Replacement Timeout (15-255 Min)
Period of 15-255 minutes from which the secondary base station takes over the position of the primary base station in the event of a timeout.